Jes extender - Trouble getting my dick stretched enough to strap it.

[coldenoughtochillmybones Junior Member Find all posts View Profile Close coldenoughtochillmybones]

So my penis is 6 inches erect length, but I can't stretch it more than 4 inches flaccid with my hand.

I placed it on the extender, with rods of size aiming for those 4 inches stretched length, then I rotated the screws for the pressure rods and it stretched my dick to 5 inches and the pressure marks didn't move, so I was getting no pressure.

Knowing my penis was only stretched at 5 inches in the extender when it is 6 inches erect, I knew obviously I wasn't getting any stretch here, I looked up pegym and some guys here said I need to add more length to the rods if the pressure rods aren't giving pressure.

So I increased the rods size to around 6 inches before turning screws of the pressure rods, the problem is can't stretch my dick enough to strap it on, and if I go lower than this I get my dick strapped but the rods won't give me pressure.
I tried going erect inside and then strapping it slowly as the erection fades away but it is complicated doesn't work.

Anybody here got some advice to get this bad boy strapped or am I using rods too big now???

PS:
I don't know what's bugging me more, the fact I wasted 200$ or that my dreams of getting 7.5 inches erect length and fixing my 40º degree curve seem to be dead.

Also, the white plastic thing where you strap your dick, for me came deformed with a bit of plastic sticking inside the tubes, I had to grind them down with a pair of scissors before I got to try the extender...

[dodgy Senior Member Find all posts View Profile Close dodgy]

I don't see how your stretched flaccid can be 2" shorter than erect length, are you sure you can't stretch it further before attaching?

[Dangler Senior Administrator☼ Wizard ☼ White Tiger Award 2015 Find all posts View Profile Close Dangler]

Warming with a mild heat source along with some gentle stretching/jelqing would help to bring out some of that hidden penis length. Allow about 15 to 20 min of warm up/exercise to do that.

Then fasten in.

Your first 2 weeks use minimal pulling force. You want to get acclamated to wearing the extender and work through the fastening process.

Don't get impatient, or get in a hurry.

[BobbyR_SG_Rep Official Size Genetics Representative Find all posts View Profile Close BobbyR_SG_Rep]

If you cannot stretch to your erect length then stretch as far as you can without causing discomfort and with enough reserve so your penis does not slip out of the device.

[ToyEnvy Member Find all posts View Profile Close ToyEnvy]

Agreed with both of the above, warm up well (rice sock, hot shower, whatever method you prefer) stretch to max flaccid stretched length and strap in, extend the device as much as you can without adding rods or until the tension rods begin to compress and wear it like that for a few hours, take a break repeat the process. After a few weeks, maybe even less, you'll find that your flaccid stretched length will start to close the gap with your erect length, at which time you'll be able to add rods and extend under tension, gradually increasing both length and tension until you're extending beyond BPEL. Don't be surprised if it takes you a month or more to get to extending beyond BPEL.

[coldenoughtochillmybones Junior Member Find all posts View Profile Close coldenoughtochillmybones]

I didn't even think about warming up, I guess I was so eager to try it.
I will try warming up first and see if this loosens up a little bit to stretch it more.

Thanks for your advice guys, I will keep you updated.

[coldenoughtochillmybones Junior Member Find all posts View Profile Close coldenoughtochillmybones]

Update: I have been warming up in the shower and manually stretching, after a few days I tried again and now I warm up before every session and I can stretch it more and fit it in the extender with right size rods that give pressure. thanks guys.

[Dangler Senior Administrator☼ Wizard ☼ White Tiger Award 2015 Find all posts View Profile Close Dangler]

Well done, thanks for the update !