Tweet
I just received the Penimaster-Pro yesterday from Germany. While waiting for the shipment, I watched the training videos on their website. I put it on and stretched for 6 hours. I used the "belt" method (i.e., connecting the stretch belt, wrapping halfway around waist, under leg, and clipped at the thigh). It was difficult to NOT get stimulated to erection, so I did everything possible to distract myself. At the end of the 6 hours, I went to get up from the chair to remove it, and my penis slipped out. There was a lot of seminal fluid (NOT semen - the clear fluid that comes out during erections) in the chamber and I ended up having an abrasion on the bottom of the glans near the tip (NOT circumcised).
These questions weren't covered in the training videos, so I hope that some more experienced users will have the answers:
1) Should I insert when flaccid or semi-erect?
1a) How do I determine what size latex part to use? I'm below average in size because of years of low testosterone causing shrinkage.
2) The website doesn't have a recommended "break-in" and/or training schedule. Did I overdo it by doing 6 hours to start?
3) I used the comfort gel (very little like the website instructed), but the chamber was full of seminal fluid.
4) I kept going from flaccid to erect throughout the time - is this normal?
5) Is the seminal fluid the reason it slipped out? I think that I only had the glans inserted into the chamber (as instructions show).
6) Any ideas as to how it got the abrasion?
7) Any tips for not getting erections while using it - i.e. masturbate BEFORE use so there's no excitement during?
8) Anyone's experience on how long the consumables (latex parts) last so I can order more and not interrupt the schedule?
I realize these are a lot of questions, but I don't want to injure myself and though I think that this is the most elegantly simply designed device, they lack all of the little things that happen to the "average person".
Thanks in advance,
Geoff
These questions weren't covered in the training videos, so I hope that some more experienced users will have the answers:
1) Should I insert when flaccid or semi-erect?
1a) How do I determine what size latex part to use? I'm below average in size because of years of low testosterone causing shrinkage.
2) The website doesn't have a recommended "break-in" and/or training schedule. Did I overdo it by doing 6 hours to start?
3) I used the comfort gel (very little like the website instructed), but the chamber was full of seminal fluid.
4) I kept going from flaccid to erect throughout the time - is this normal?
5) Is the seminal fluid the reason it slipped out? I think that I only had the glans inserted into the chamber (as instructions show).
6) Any ideas as to how it got the abrasion?
7) Any tips for not getting erections while using it - i.e. masturbate BEFORE use so there's no excitement during?
8) Anyone's experience on how long the consumables (latex parts) last so I can order more and not interrupt the schedule?
I realize these are a lot of questions, but I don't want to injure myself and though I think that this is the most elegantly simply designed device, they lack all of the little things that happen to the "average person".
Thanks in advance,
Geoff
Valued Member of
Comment