Testicled Sucking and Keeping the Size

[Testicular Acrobat Senior Member Find all posts View Profile Close Testicular Acrobat]

First the testicle sucking issue:

1. I have two tube sizes: a 2" and a 2.25"
2. I use the 2" for a few minutes until it's filled up. Seems like if I go in flaccid and get erect after being pumped, the size is bigger faster, as compared to going in already hard. Seems like that anyway.
3. When I switch from the 2" to the 2.25" tube, it's difficult to get out of the 2". My penis is so swollen in there that it takes some finagling to slide off the tube, even lubricated. It isn't painful, just really tight in there.
4. I have one of those soft silicone gasket things from LeLuv on the 2.25". The 2" has what look like a hard rubber doughnut on it and no testicle suction there. But with the "large" gasket from LeLuv on the 2.25" tube my penis won't fit through that, so what I do is press the head up against the gasket entrance and pump. The suction then pulls my penis inside.
5. After filling up the 2" I switch to the 2.25", and here's the problem: twice now, I've had a testicle get sucked in. My GOODNESS that is an unpleasant feeling!!!! It's actually horrible and I am traumatized, because its happened out of the blue when I've had the cylinder on for a bit. Does anyone have the same experience? Any suggestions? I don't understand how my testicle gets sucked in if my penis is filling up the bigger tube.
6. Seems like I need a lot more pumping in the 2.25 to reach even 2 or 3 in HG Vac. But it works.
7. While in the 2.25", my penis grows even more, but is not filling up the tube, so that's good I guess.
8. Pulling out though is very difficult: The gasket seems ok around the base, but pulling out is really difficult because my penis has swollen so much. I have to use my fingers to stretch the gasket, but that is also really difficult. Towards the end it's a little painful because I have to get the head through the much smaller opening of the gasket.
9. Sometimes I have gotten some puffyness on the circumcision scar. It goes away after a while.
10. Now the keeping the size issue:
11. When I'm out of the larger cylinder, my circumference is between 6.25 and 6.5". Length is almost 6.5. This is even with it going flaccid, which is impressive. I haven't done anything for length and am not sure I will. I do, however, stretch it a bit afterwards and do helicopters.
12. Is there anything I can do to help cement that gain? I'm not an exhibitionist, but if does feel good having that thick and heavy thing hanging there, and my wife is very impressed.
13. One thing I've considered is to wear the 2.25" around the house after the session at a lower vacuum, like 2, and just let it hang, for as long as possible. Have even thought of attaching a little weight to the end of the cylinder to help it pull more.
14. Another thing is wearing a cock and ball ring, but I have found the process of sizing to be really difficult, especially with steel open/horseshoe types. And they are pretty expensive to be unsure.
15. I have been thinking of making a leather cock and ball ring though.
16. Does wearing a cock and ball ring after these session help cement the gains?

Any advice and suggestions are welcome.
Thanks!

[not2big Senior Super ModeratorPEGym Hero Find all posts View Profile Close not2big]

When entering the 2.25 inch cylinder, try to hold the cylinder as tight as you can against the bottom of your shaft. It helps but is not always successful.

When pulling off the cylinder try pushing in a lubricated tooth brush handle between shaft and cylinder wall to allow in air which should reduce the vacuum resistance.

Some say using a cock ring helps with cementing. I feel total time under vacuum is the best way to cement girth gains

[Testicular Acrobat Senior Member Find all posts View Profile Close Testicular Acrobat]

When entering the 2.25 inch cylinder, try to hold the cylinder as tight as you can against the bottom of your shaft. It helps but is not always successful.

When pulling off the cylinder try pushing in a lubricated tooth brush handle between shaft and cylinder wall to allow in air which should reduce the vacuum resistance.

Some say using a cock ring helps with cementing. I feel total time under vacuum is the best way to cement girth gains

I just got an email from LeLuv saying that, while the gasket things I have will work, the right ones are another type. Maybe that will help with the testicle suction. So I'll get those asap and see.

When pulling out from the 2" cylinder there is no room for a toothbrush-I'm squeezed in there so tight I can't get anything in. But that isn't much of an issue really, as it does slowly slide out.
The issue is with the 2.25. The gasket is so tight that it's difficult to remove because my penis swells to much more than the diameter of the gasket. But now that I found out the right gasket, this may solve the issue.

SO cementing is the thing now.
I'm wondering if multiple sessions of pumping per day is good. Also, if higher pressure or lower. I usually pump at 5, and sometimes increase to 9 for a bit.

[not2big Senior Super ModeratorPEGym Hero Find all posts View Profile Close not2big]

When I was actively pumping, I did a 20 minute session at 5 hg in the morning and at night, six days a week and once a week a 45 minute session at 4 hgonce a week. I also included some pulse pumping.

[Testicular Acrobat Senior Member Find all posts View Profile Close Testicular Acrobat]

When I was actively pumping, I did a 20 minute session at 5 hg in the morning and at night, six days a week and once a week a 45 minute session at 4 hgonce a week. I also included some pulse pumping.

Did that provide results?
Why did you stop pumping?