Extender keeps slipping off

[Deleted Junior Member Find all posts View Profile Close Deleted]

Hello.

I've been using a penis extender for about a week now, and it seems like when I sit down or walk around, the noose slips over the head and the device falls. Now, if I make the noose VERY tight, it stays. However, this causes extreme pain.

What can I do to ensure the penis extender's comfort and security?

[closeed258 Senior Member Find all posts View Profile Close closeed258]

I have the same problem when I use strap or noose and need this answering too!!

[Banana Bender Senior Member Find all posts View Profile Close Banana Bender]

Well, look ... I haven't found any total answer to the issue, but I do make the noose pretty tight! However, I only stay in for half an hour at a time. I don't let the dick head get numb. (I also go 'bareback' without all those comfort bands, etc. I think it gets a better grip that way, as well.)

But you can also try:

1. Micropore tape wrapped around the noose where it meets the head
(or micropore tape on the shaft and groove of the corona
2. Talcum powder on noose and corona
3. Replacing the noose regularly - the silicon gets worn
4. Starting the extender at less than full strength for strap in, and then winding the extender out from the base until you get full stretch.

Failing all of the above, you might have moved too fast with the extender and you've stretched it out faster than your dick!

But I have to say, these things are not perfect. It is very uncomfortable and strange to walk around with something gripping your penis and stretching it out (makes me irritable and cranky). And they do fall off! I just have to drop something on the floor, bend over to pick it up, and ... damn, there it goes again - and now another 5 minutes or more to strap in all over. How many times a day must this happen?

[Deleted Junior Member Find all posts View Profile Close Deleted]

Hmm, is it possible I'm just using it incorrectly?

[closeed258 Senior Member Find all posts View Profile Close closeed258]

I think the problem I have is my stretched flaccid girth, it's very thin and thats why it slips off

[rhinoguy Senior Member Find all posts View Profile Close rhinoguy]

Try using cord instead of tube for noose material. Also, try slightly smaller diameters. If you search "Carr McMaster" I posted some noose materials that worked for me they sell.

[funflyer Senior Member Find all posts View Profile Close funflyer]

I have never had problems with slipping unless the silicone noose was worn or I was over stretching. If the silicone is worn it slips out of place and loosens. If I over stretch I am simply putting to much tension on my glans and it pulls free. See if you can determine if this is the cause and fix it. I can wear mine for hours on end without it falling off.

[crs Member Find all posts View Profile Close crs]

I wish I had more knowledge to help you because I don't use the noose I use the strap (X-4) but one thing that I didn't see any other post tell you is to make sure you have a nice head swell, even using the strap like I do it helps tremendously to keep it all in there.
Also I think you need to be proportionate with your flacid length and how many rods you are using, it's better to have a shorter rods to accommodate your flacid then turn the screws to adjust for more tension. Soon enough you will need to add more rods

[rhinoguy Senior Member Find all posts View Profile Close rhinoguy]

I wish I had more knowledge to help you because I don't use the noose I use the strap (X-4) but one thing that I didn't see any other post tell you is to make sure you have a nice head swell, even using the strap like I do it helps tremendously to keep it all in there. Also I think you need to be proportionate with your flacid length and how many rods you are using, it's better to have a shorter rods to accommodate your flacid then turn the screws to adjust for more tension. Soon enough you will need to add more rods

^^^ all true. Good comments. When I was using a noose I always spent the first 15 minutes jelqing for head swell. Also, the rod length is critical. Back off until you can keep it on and do not get caught up in the thing about always adding rods. The goal is extending, not adding more rods to feel good about how long you are.

[DemOne Banned Find all posts View Profile Close DemOne]

Try using cord instead of tube for noose material. Also, try slightly smaller diameters. If you search "Carr McMaster" I posted some noose materials that worked for me they sell.

McMaster-Carr*

[crs Member Find all posts View Profile Close crs]

Thanks RhinoGuy, I don't jelq personally at the start I find myself getting to hard and maybe it's just in my head but I don't like to be hard when using my extender.
I do stretch for a few minutes just to loosen up everything, should have said that in my previous post oops, that really helps out alot.

heli shakes and pulling in all directions, heli shakes give me a nice and easy head swell just before i suit up

[EightIncher Junior Member Find all posts View Profile Close EightIncher]

I'm "REALLY" late replying to this. I have an extender that I've been using off and on for about 2 years. I get frustrated with it because when I increase the tension, it slips off. I can't even seem to reach my normal erect length. Finally, I thought about talcum powder so, I bought a medicated powder, similar to Gold Bond and applied that to the head and corona and about an inch or so further down.
Now I can wear the extender for hours. I can increase the tension and it stays on very well. Anyway, better late than never but I have found this to be my secret. Also, I wear a wrap around the lower half of my shaft. Sometimes the extender pinches and hurts pretty good but the wrap protects me so I can wear clothing, or not and when I move I don't get the pinch.

Good luck

[miami-cock Senior Member Find all posts View Profile Close miami-cock]

Velcro mod.

[Captainzombie79 Junior Member Find all posts View Profile Close Captainzombie79]

Hello.

I've been using a penis extender for about a week now, and it seems like when I sit down or walk around, the noose slips over the head and the device falls. Now, if I make the noose VERY tight, it stays. However, this causes extreme pain.

What can I do to ensure the penis extender's comfort and security?

Hey bro, I had the same problem as you, every time I tried to put it on eventually my penis got a bit flaccid and it fell right off... and if I tightened it too much to keep it on my head got numb and started to turn purple. I tried it for about a week and just about gave up on it, but in my mind I knew there had to be a way. then I saw a video of someone putting one on with tape under it... so I went to the hardware store, asked if they had any tape that was like rubber... the funniest thing, the woman led me to a new product called Rescue tape. They even had a video playing showing all the uses. it sticks to itself, is soft and so far has been comfortable. It cost around 10 bucks and is worth every penny, and it's reusable. https://www.rescuetape.com/ I just wrapped once and a half around right below the head, the silicon from the tape sticks like glue to the silicon from the extender keeping it on and in place, no matter how much you stretch it, it won't fall off. so far it's been on my dick with me moving around and everything, even sleeping in it works. Honestly I think the extender should come with a roll of this stuff cause it's a miracle product that seems to be made for it. Oh, and the best thing about this, cause the tape holds to your skin and to the device, you don't have to tighten it to where your head goes numb. PS, there isn't anything sticky on the tape, just the type of material that is used naturally sticks to things like plastic and itself. Give it a try and you'll be gaining in no time.

[SwAngin Senior Member Find all posts View Profile Close SwAngin]

okay hopefully I am NOT repeating anything. I did not feel like reading through everyone's posts.

I kind of used to have the same problem when I used my extender. There are a few things I did to make sure it did not slip.

the first thing I did was tear a small piece of toilet paper and fold it a couple times. This piece you tear off is very small its not a whole square or anything. That is placed where the noose latches in underneath the head mount. It kind of makes it a tighter fit so that way the noose won't slowly loosen up overtime.

also the second thing I did was make sure you have a big head swell. Basically put the extender on and keep the springs compressed and have the noose attached already around your penis. But have the noose at around 80% tightness to where you want it. Once that is said and done you want to keep the springs compressed. While the springs are compressed dry jelq as much blood as you can to your head to make it swell up. Once you have a good head swell tighten the noose to 100% where you want it.

I hope this helps, it solved my problems