New hanging method

[bigforasia Junior Member Find all posts View Profile Close bigforasia]

Hello i have been around this forum here for a while, just reading stuff, never done any hanging or exercising myself because i dont have the time and privacy for it, but i am willing to try when i get the chance, anyways i am an engineer with a college degree and i only believe in hanging so i mainly read articles and forums about hanging. When hanging the penis is usually stretched in 1 direction, and the device that is used for it is occupying a lot of the shaft itself that is supposed to be stretched ( the part occupied by the device doesnt get stretched right? ), so that really bothered me and i thought of this kind of method, to use vacuum cap or some other method to attach a rope to the glans and then the rope around your neck, then using a weight, which is placed in midshaft. This way, from an engineers perspective, the penis gets stretched in two directions, from the base to midshaft and from the tip to midshaft, thus the results should double, right?

i attached a fast drawing i did in paint to clarify my thoughts

[Glamissand1 Senior Member Member of the Month March 2014 Find all posts View Profile Close Glamissand1]

First glans attachment for any reason is bad, due to the low stress load the glans can handle. Second the penis will start to take on the weighted form, ending in a bent penis. Try hanging first before changing its design, bib has a great setup for hanging and even has reduced attachment area.

[Padawan787 Moderator ReservePEGym Hero Find all posts View Profile Close Padawan787]

Sorry to burst your bubble but vacuum hangers already exist Vacutech make them, and there is a small section about vacuum hangers in our hanging 101 sticky: https://www.pegym.com/forums/penis-d...ing-101-a.html

The main problem with vacuum hanging is maximum weight, here is an extract:

Vacuum Hangers: (e.g. AutoXleeve, VacExtender)There's a fairly short learning curve on attaching these devices, since a wrap is not an absolute requirement. However, most VAC hangers, especially those using higher weights find that they absolutely must use tape to protect their glans. 3M makes a special Micropore tape that leaves no residual; most VAC hangers use this.


You also don't need to worry about taking breaks every 20 minutes. Many Vacuum hanging PEers find that they can maintain blood flow while hanging. This means, substantially less work is required vs. a traditional hanger. Remember, every time you attach a traditional hanger, you've got to get the settings right, which can be difficult at first, and still tedious even if you're an advanced hanger. If your wrap gets loose, or is falling off, you may also be forced to re-wrap (more of an issue with traditional hangers).


Despite the great advantages of Vacuum hanging, there are still some downsides. You can't go beyond 15lbs to 20lbs (compare that to a traditional hanger where there's virtually no weight limit). At higher weights, the VAC hanger either causes too much pain or or the silicone sleeve tears (expensive). There are also reports that using a vacuum hanger for many years can cause a raised whitish circle on the glans. In fact, the same effect has been reported with extreme usage of VAC ADS Extenders as well. Overall, there have been numerous reports that VAC hangers can make your penis ugly. Based on anecdotal evidence, it appears this is more of a concern with heavy VAC hanger usage.


Most manufacturers give you a few disposable silicon sleeves when you first purchase a VAC hanger, but eventually they will all tear with prolonged use (or increased weight). Then, when you attempt to buy more silicon sleeves they are usually overpriced. Lots of VAC hangers have tried to make their own silicon sleeves, but often this ends up being just as expensive if not worse. Over months and years VAC hanging eventually becomes several times more expensive than traditional hanging due to the inevitable need to continue replacing the silicone sleeves.

EDIT: Glamissand raised the excellent point of penile curvature, and I would personally avoid attaching anything to the glans.

[BigO AdministratorPEGym Hero Find all posts View Profile Close BigO]

I am not an engineer but I did play a doctor on TV.

[bigforasia Junior Member Find all posts View Profile Close bigforasia]

So when it will influence on the penis shape it can also be used as a cure then for a downward bend, which i do have. Imo using my new method you put the stress right there where it is mostly needed, on the shaft, its like an inverse A stretch.

[BigO AdministratorPEGym Hero Find all posts View Profile Close BigO]

So when it will influence on the penis shape it can also be used as a cure then for a downward bend, which i do have. Imo using my new method you put the stress right there where it is mostly needed, on the shaft, its like an inverse A stretch.

It may work, as with most PE some one tried and found out. Give it a shot for a while and let us know how it works. I would be interested in your results.

[smerc Member Find all posts View Profile Close smerc]

There is a thread about this 'type' of stretch on another forum(not sure if I can name it here).
Which is a v-stretch using only your hand and a kettlebell. Seems to be very effective from the reports. It's just hard to hit different angles.

[Padawan787 Moderator ReservePEGym Hero Find all posts View Profile Close Padawan787]

There is a thread about this 'type' of stretch on another forum(not sure if I can name it here).
Which is a v-stretch using only your hand and a kettlebell. Seems to be very effective from the reports. It's just hard to hit different angles.

Yes, you can, we welcome links to other PE forums Collaboration is key.

[smerc Member Find all posts View Profile Close smerc]

It definitely is.

Here is the thread: Kettle Bell Thread (by Dickleaker)
-----

"My theory on why the kettlebell V stretch/hanging is so good because you are doing 2 stretches at the same time...the weight at the base of ur dick is pulling on the ligaments and the high angle you need to hold ur dick to keep the weight in place streches out ur inner penis!"

-----

"I put my penis through the handle, then pull my glands up to my belly button and lift the kettlebell. I hold that for a couple minutes pretty much. That is the V stretch kettle bell style!"

-----
Some people use 5lb kettlebells then work their way up to 10-15lbs.
Walmart has a set of the 5-10-15lb golds gym kettlebells for $38 (cheapest I have seen), but you would probably need to place foam around the handle loop.
They're also one of the best if not the best weights for workouts(BBing) from what I hear.
-----
There are also some DIY kettlebell style weights you can make by using regular weights and handles listed on pg. 7.