Announcement

Collapse
No announcement yet.

Bathmate Problems

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Bathmate Problems

    Guys I'm having real problems with my Bathmate and I'm becoming pretty discouraged. I started with the Hercules, and I found after a couple of uses the one way valve at the end was letting air in after I pumped, I sent it back and got a replacement, Then after a few uses on the replacement the 2nd pump had the same problem, the one way valve at the very end wasn't one way!
    So they company suggested a bigger stronger pump so I got the x30. I now have two problems with the x30, either my penis bends inside the pump, which is painful or it wont seal against my groin. I just can't get into a rhythm or get any long term use. Any suggestions or anyone else suffered the same problems? Love some advise
    P

  • #2
    Thread has been moved to the Penis Devices Forum.
    To totally satisfy a woman sexually is not about having a large penis, it's about being a good lover.

    Comment


    • #3
      No that's not normal. The cylinder itself might be the problem if multiple valves aren't resolving the problem. Check to see if you can turn it in for an exchange with the site you got it from.
      PEGym APPROVED! The lowest price on the net for bathmate pumps GUARANTEED!

      BathPump Pumping Routine- GET STARTED HERE

      Comment


      • #4
        Are you going into the pump erect? I found this helps with most issues!
        Starting Point: September 2010: 6.5" x 5"
        Goal: 8" x 6"

        Follow my blog if you like :D
        Trying to spread PE to a bigger audience, money off some Penis Devices too!
        http://penisenlargementandhealth.blogspot.com/

        Comment


        • #5
          You can go into the pump flaccid and pump yourself to erection. This shouldn't be a problem is the pump is working properly.
          PEGym APPROVED! The lowest price on the net for bathmate pumps GUARANTEED!

          BathPump Pumping Routine- GET STARTED HERE

          Comment


          • #6
            If you're penis bends put some lube on it I had a similar problem and corrected it with small very small amounts of lube

            Comment


            • #7
              Hi guys thanks for all your help, I made some changes based on what you some of you suggested and its really helped, so here are some tips from me that I discovered, that will hopefully help any newbies having the same problems.


              1 - Shave your pubic hair off, I just trimmed it really short, but when I shaved this made a huge difference.
              2 - I don't have a bath, but I found that using the BM in the shower with the water running directly over the seal and my groin, greatly reduced air leaks.
              3 - When I was pumping I would leave the pip open, just assuming the vacuum was enough, closing the pip after every pump also made a big difference.
              4 - A great tip I got was "only pump our water/increase pressure at intervals, when I lose seal it's because I try to pump out water in multiple pumps. So - pump out some water....wait 30 seconds, repeat." This is a great tip because I was pumping, pumping, pumping until I couldn't get any more air out, by waiting 30 seconds between pumps, its made a big difference to the seal.
              5 - I also found that I don't bend inside the BM, if I'm hard or semi hard beforehand. When my dick was flaccid, it just bent to much, so now a quick perv at some porn and then straight into the shower.


              Hope this helps any other newbies struggling with the BM.


              Some further questions, how long have you been using the BM and what improvements have you seen in that time?
              Also how long to you abstain from an orgasm after a BM session
              Thanks in advance
              T

              Comment


              • #8
                Good advice! I recently purchased the hydromax x40 about a week ago and at the start i was having some issues getting a good seal and if flaccid getting caught on the sides. I also found a semi to help a lot. I haven't tried a full erection as from reading up it seemed like a bad idea to start being it's apparently too intense. I've been doing my workout in the bath but I'd like to switch up to the shower as it's not as time consuming

                Comment


                • #9
                  Originally posted by bm_x40 View Post
                  Good advice! I recently purchased the hydromax x40 about a week ago and at the start i was having some issues getting a good seal and if flaccid getting caught on the sides. I also found a semi to help a lot. I haven't tried a full erection as from reading up it seemed like a bad idea to start being it's apparently too intense. I've been doing my workout in the bath but I'd like to switch up to the shower as it's not as time consuming
                  Use lube and trim or shave pubes to get a really good seal.
                  PEGym APPROVED! The lowest price on the net for bathmate pumps GUARANTEED!

                  BathPump Pumping Routine- GET STARTED HERE

                  Comment

                  Working...
                  X