Off the scale
This week I did another two pumping sessions with my cut-off Crystal Skin silicone sleeve. Both were 2x30 minutes with 5 minutes pause, but during this pause I kept the pressure at just 1 inHg the other time. A little doughnut-warning after that session, but it went away sometime during the night.
When I was going to check my in-cylinder length at the end of the second long session this week, the top of my penis disappeared behind the black plastic top of my cylinder. That is a little irritating behaviour of my expanded friend, but it sure do feels good to see it get so long :-)

I did take a couple of photos of my penis with the Crystal Skin silicone sleeve, I'll try to post them in my photo album here soon. Edit: Photos added to my Vacuum pumping photo album.

* NOTES for week 23 *
* Monday: Jelq, 80 strokes (40 reps). Then uli 3*45 seconds.
* Tuesday noon: Jelq, 20 strokes (10 reps). Then uli 3*45 seconds.
* Tuesday night: Pump, 2x30 minutes at 5 inHg (with a 5 minutes pause), for the second time wearing my Crystal Skin silicone sleeve with a cut-off top. Started each of the two session-parts with slowly going up to 7 inHg and then lower it to 5 inHg. In-cylinder length at the end was 20,3 cm (7.99 in) at 5 inHg and 20,4 cm (8.03 in) at 6 inHg. Afterward I did 10 minutes edging before stepping over the edge with great pleasure :-)
* Wednesday: Pump, 2x30 minutes at 5 inHg (with a 5 minutes pause at only 1 inHg), for the third time wearing my Crystal Skin silicone sleeve with a cut-off top. Started each of the two session-parts with slowly going up to 7 inHg and then lower it to 5 inHg. In-cylinder length at the end was 20,4 cm (8.03 in) at 4 inHg, then off the scale... approximately 20,5 cm (8.07 in) at 5 inHg and 20,6 cm (8.11 in) at 6 inHg. No edging this time.
* Friday: Jelq, 110 strokes (55 reps) during 15 minutes. Then uli 4*30 seconds.

Remark: 4 mm has been added to all in-cylinder measurements since they have been done with an extra latex sleeve mounted on the cylinder. This adjustment gives values consistent with measurements made before this extra sleeve was mounted.