Revisited my old pump
This week I made a couple of high scores using my new pump and was wondering how it would be to use my old pump again. So I retrieved it from the storage box, pressed in my almost hard penis with some difficulty through the sleeve and started pumping. I had some problems maintaining the pressure, did not seem to get a firm seal between the cylinder base and my body. Well, at least I managed to pump for 10 minutes with the pressure most of the time up at 6 inHg. At the end I checked the cylinder's scale... the tip of my penis was hiding under that black plastic top of the cylinder, but I estimate that it was about 2 mm above the 20 cm marking. So when adding the ususal 4 mm for the extra sleeve I got an in-cylinder length of 20,6 cm (8.11 in).
This can be compared with notes from week 35, where I had 20,4 cm (8.03 in) after 10 minutes at 6 inHg (but with first two minutes at 7 inHg) and 20,5 cm (8.07 in) after a 15 minute session at 6 inHg.
So... some gains have certainly been made during these last weeks with my new cylinder :-)

During the next following weeks I will be on summer vacation and since I will be travelling around quite a bit during these weeks I will probably do little PE and little blog updates.
Happy summer everybody!

* NOTES for week 45 *

* Monday morning: Pump, 10 minutes at 6 inHg. 20,2 cm (7.95 in) in-cylinder length at the end at 6 inHg. 20,4 cm (8.03 in) when I did a short 7 inHg spike before ending the session.
* Monday noon: Jelq, 70 reps (140 strokes) during 10 minutes. Followed by 4*45 seconds uli.
* Tuesday morning: Pump, 10 minutes at 6 inHg. 20,4 cm (8.03 in) in-cylinder length at the end at 6 inHg. 20,5 cm (8.07 in) when I did a short 7 inHg spike before ending the session. Both measurements are new high scores!!! Directly afterwards I had BPEL = 20,1 cm (7.91 in), also new high score for after a 10 minutes pump session.
* Tuesday noon: Jelq, 40 reps (80 strokes) during 5 minutes. Followed by 4*45 seconds uli.
* Tuesday afternoon: Pump, 10 minutes at 6 inHg. 20,3 cm (7.99 in) in-cylinder length at the end at 6 inHg. 20,4 cm (8.03 in) when I did a short 7 inHg spike before ending the session.
* Wednesday morning: Pump, 15 minutes at 6 inHg. 20,3 cm (7.99 in) in-cylinder length at the end at 6 inHg. 20,4 cm (8.03 in) when I did a short 7 inHg spike before ending the session. Directly afterwards I had BPEL = 20,1 cm (7.91 in).
* Wednesday noon: Jelq, 80 reps (160 strokes) during 10 minutes. Followed by 4*45 seconds uli.
* Wednesday afternoon: Pump, 10 minutes at 5 inHg. 20,1 cm (7.91 in) in-cylinder length at the end at 5 inHg. 20,3 cm (7.99 in) at 6 inHg and 20,4 cm (8.03 in) when I did a short 6-7 inHg spike before ending the session.
* Thursday early morning: Pump, 2 minutes at 7 inHg + 2 minutes at 6 inHg.
* Thursday late morning: Pump, 2 minutes at 5 inHg + 2 minutes at 6 inHg + 2 minutes at 7 inHg. 20,3 cm (7.99 in) at 7 inHg at the end. Afterwards BPEL = 19,9 cm (7.83 in).
* Thursday noon: Jelq, 80 reps (160 strokes) during 10 minutes. Followed by 4*45 seconds uli.
* Thursday afternoon: Pump, 10 minutes at 6 inHg. 20,2+0,4 cm (8.11 in) in-cylinder length at the end at 6 inHg. Note 1: Used my old pump, see blog text above.
* Friday morning: Pump, 4 minutes at 5 inHg + 4 minutes at 6 inHg + 2 minutes at 7 inHg. In-cylinder length 20,4 cm (8.03 in) at 7 inHg at the end. Then I released the pressure and built it up to 7 inHg again, resulting in in-cylinder length 20,5 cm (8.07 in). Afterwards BPEL = 19,8 cm (7.80 in).

Note 2: Almost all pumping this week done with new "Mr B" pump and 2" cylinder. See photo in my album.
In-cylinder lengths are measured with a ruler outside the cylinder.