ShaneC Phallosan Progress Log

[ShaneC Senior Member Find all posts View Profile Close ShaneC]

Been concentrating on girth work lately, and I am happy to see that it finally gives results.

Im up from 5,1 to 5,3 MEG in roughly a month of mostly doing dry jelqs/slow squeeze combined with edging and some clamping now and then. I have tried to do two or three sessions a day, one main session, and a couple extra sessions each time I went to the toilet if I had the time. The just edging for a few minutes and tried to count up to a total of 100-200 dry jelqs. I also put in some squeezes for like a minute or so after the jelqs. So far so good

[Penilenvy Member Find all posts View Profile Close Penilenvy]

Shanec,

Where did the blister appear on you dick and what caused it do you think?

1 am 100 hrs in on the PF. I took a 4 day break because my Glan started getting red and very sensitive. Back in it today.

[Penilenvy Member Find all posts View Profile Close Penilenvy]

I wear it for 10 hrs at a time. Usually 4-5 days a week and not at night.

[rippem Banned Find all posts View Profile Close rippem]

Shanec does the inside of the bell when you take it off have moisture in it? And do you only wear it when you sleep or are you a wake?

[ShaneC Senior Member Find all posts View Profile Close ShaneC]

Shanec,

Where did the blister appear on you dick and what caused it do you think?

1 am 100 hrs in on the PF. I took a 4 day break because my Glan started getting red and very sensitive. Back in it today.

The blister appears on the right hand side of the glans about half an inch from the urethra, on the upper part. What caused it is almost certainly a small pocket of air trapped inside the protective cap.

Be aware, and stop using the PF if you get blisters and let them heal completely before you continue. If your glans is getting red and sensitive it may be because of to many hours before you are used to wearing it, or the tension is to high.

[ShaneC Senior Member Find all posts View Profile Close ShaneC]

Shanec does the inside of the bell when you take it off have moisture in it? And do you only wear it when you sleep or are you a wake?

Yes, the inside sometimes had moisture, like some kind of sweat or something. It is very important to make sure every drop of urine is completely gone after taking a leak or you will be red and sore. I have tried once to use it at night, but could not fall asleep with it, so I have only used it at daytime.

[ShaneC Senior Member Find all posts View Profile Close ShaneC]

Starting up again This time not retracting the foreskin.

I have tried so many times just ending up with a blister on the same spot, again and again. Even just a couple of hours in the low green zone would make the blister appear.

So I thought I would try leaving the foreskin, and so far it seems to work. Have gradually inceeased hours, and yesterday I managed 10 hours without any pain or blisters, just some puffiness at the foreskin.

I read in the device thread that Julian from Phallosan did not retract the foreskin, and that this shouldnt matter. It also says likewise at the Phallosan Q&A Pages.

So far:
2
4
6
8
10
Total 30 hours

[poste Member Find all posts View Profile Close poste]

You should try wrapping your glans with 3m micropore tape. I use 2 strips covering mostly the urethral opening. I'very been able to sleep with it on, whereas before I would get a blister or two every now and then.

[ShaneC Senior Member Find all posts View Profile Close ShaneC]

Thanks, will buy some 3m micropore tape and try

70 hours. 11 hours without takling it off today. No problem so far, just the puffiness, but it disappears rather quickly.

[ShaneC Senior Member Find all posts View Profile Close ShaneC]

147 hours. Average of 8-9 hours a day. Hard to keep it longer. Tried different approaches, with/without foreskin retracted. Tried 3m micropore tape. Worked for a while, but then I got red and itchy on the tip and had to change.. sigh

[peckerachu Banned Find all posts View Profile Close peckerachu]

147 hours. Average of 8-9 hours a day. Hard to keep it longer. Tried different approaches, with/without foreskin retracted. Tried 3m micropore tape. Worked for a while, but then I got red and itchy on the tip and had to change.. sigh

Hi there, I'm eagerly awaiting my PF and this thread makes me so motivated. I'm aiming for 24hour per day use at 1,5 pounds of tension and only 1 pound when sleeping. So definately need to find a comfortable way to wear it, though I think the lower the tension, the lower the vacuum pressure needed? Going to try with my foreskin inside the bell and taping up the glans under the foreskin. I will report as soon as I get it.

[ShaneC Senior Member Find all posts View Profile Close ShaneC]

24 hours a day?? I think you might want to reconsider that. Better to aim for 10-12 hours a day after a thorough break in period. Your penis will thank you

Go for low green tension as long as you can, especially going for long hours. Once you start upping the tension the risk increases for blisters, edema, sore skin etc.