Make a penis weight hanger- with routine!

[frb3 Senior Member Find all posts View Profile Close frb3]

Traction wrap?

I use Ace Self Adhering wrap.

[millia Senior Member;PEGym Editor Find all posts View Profile Close millia]

I'm new to pe, I will do the 90 day routine and then I wonder doing more advanced exercises.I planning doing hanging in the future. I would like to know if hanging hasmore benefits than pe and if i will gain faster and more than by doing pe exercises?

Hanging is a part of PE, I would hang and continue PE if I were you. Hanging does have some good qualities and will help you gain. I hang after I do my usual PE stuff.

I use Ace Self Adhering wrap.

I see, yeah I raided my parents medical stuff and found something like that, except its more of a bandage or something, it's self adhesive and somewhat comfortable.

[Waylander Retired ModeratorPEGym EditorPEGym Hero Find all posts View Profile Close Waylander]

I use Ace Self Adhering wrap.

hey frb3, do you unwrap in between hanging sets?

[Big Al AdministratorPEGym EditorMale Enhancement Coach Rep.PEGym Hero Find all posts View Profile Close Big Al]

Hey Big Al, I'm working on getting that wrapping info(I've been tied up with work). I did find a interesting post though.

"The wrap should be tight, but not too tight that it cuts off circulation. A way to see if it's to tight is to try and take a piss after you wrap. If your pee stream is cut off or effected, then it's too tight." Does that sound right?
One guy at TP highly recommends using the soft leather chamois(used for carwashes) for a wrapping material. I'm gonna try it myself and see.
Sorry if I got off topic. But it's a important part of hanging, right?

That sounds about right. It's going to take a bit of fiddling until you find just the right balance between too tight and not tight enough.

When in doubt, use more padding. That way, even if you're tied on a little too tight the padding will protect you.

[FadesIntoTheNight Senior Member Find all posts View Profile Close FadesIntoTheNight]

So you should wrap hang right before the glands? I heard someone on here hang from the base, which is better?

Also, I'm having a problem with the sock keep slipping off.

[Big Al AdministratorPEGym EditorMale Enhancement Coach Rep.PEGym Hero Find all posts View Profile Close Big Al]

So you should wrap hang right before the glands? I heard someone on here hang from the base, which is better?

Wrapping right the glans is best- that way, you'll be able to stretch the whole penis and not just the ligs.

Also, I'm having a problem with the sock keep slipping off.

You may try those silicone gel inserts I recommended. They'll keep your sock from slipping.

[millia Senior Member;PEGym Editor Find all posts View Profile Close millia]

So you should wrap hang right before the glands? I heard someone on here hang from the base, which is better?

Also, I'm having a problem with the sock keep slipping off.

For the sock slipping off you should get some form of wrap that will prevent it from doing so, I used kleenex before I discovered this self-adhesive tape, or my what a grip. Me and Waylander and going to experiment with chamois wrap as well.
I also suggest tying it twice. I tie it once close to the base and then wrap it around again to the middle part (I have slippage so by the end of my hanging set it is almost at the glans) and then tie a bunny ear knot.
And I'm going to assume that hanging from the base stretches the inner penis? But I'm not sure.

[FadesIntoTheNight Senior Member Find all posts View Profile Close FadesIntoTheNight]

Thanks, wish I didn't waste $400.00 on an extender and got a bib hanger.

[TheSizeDoctor Banned Find all posts View Profile Close TheSizeDoctor]

If you're going to spend money on a hanger, I recommend the BIB- I have one and the engineering behind it is pure genius. It's very secure and comfortable and it'll allow you to hang heavy for extended periods. If you don't have the funds [and in addition to the Home Made BIB above] you can always make your own low-tech hanger:

The Sock Hanger


IMPORTANT NOTE- DO NOT attempt to hang weights from your penis with an erection or semi-erection! You risk doing GREAT DAMAGE to your penis if you do!

There are a few penile weight hanging devices out there on the market. Many of them are expensive, uncomfortable, and have a short lifespan.

Here's how to create a COMFORTABLE weight hanger with a few items you'll likely find around your house! It's called "The Sock Hanger":

You'll need a [clean] cotton athletic sock, 2 lengths of twine or 2 shoelaces (at least 3 feet each), and something to add weight to the device (small weight disks, an emptied milk jug, etc.)

Fold the open end of the sock over on itself until you have an adequately thick layer of padding. Then, place your penis into the open end of the sock (it helps if your penis is semi-erect.)

Using one of the lengths of twine, secure the sock to your penis by looping the length of twine around the padded area and tying it off fairly tight (NOTE- use a knot similar to the knot that you use to tie your shoes or a slip knot... just in case you need to remove the hanger QUICKLY!)

Using the other length of twine, tie one end of the twine to the empty end of the sock, and tie the other end to the weight.

If you're using an emptied milk jug, add water or sand to achieve the desired weight.

It's VERY important that you don't hang for more than 15 minutes straight! After 15 minutes of continuous hanging, remove the hanger and massage your penis for at least five minutes. Wait a total of 15 minutes before attempting to hang again.

IMPORTANT!!!- Under NO circumstances should you start weight hanging with more than 2 or 3 pounds. Work up in weight SLOWLY! You can cause a lot of damage to your penis if you overdo it! Also, hanging should NOT be painful or cause extreme numbness!


Advanced Hanging for Repetitions

Here's an advanced method of hanging that will help you add more length than you ever though possible! Before starting this advanced method, hang light for about 5 to 10 minutes to adequately prepare the penis for the intense stress to follow!

To perform the "Advanced Hanging for Repetitions" method, find someplace to sit where, with your rear end on the edge of the seat, your legs will bent at the knee at a slightly greater than 90 degree angle.

Set up your Sock Hanger with a heavier weight that you normally use, but set it up in a way to where, while leaning forward a bit, the weight will [barely] be touching the ground. Now lean back a bit so that the weight is raised off of the floor.

Lower and repeat.

Start off with about 50 repetitions and work up from there.

Some other advanced hanging techniques can involve:

- Swinging the weight a bit while hanging

- "Stripping Sets"- where you hang heavier than normal and strip the weight every few minutes

- Leaning back while hanging. BE CAREFUL! You WILL feel an intense stretch doing this!

- Getting up and walking around while hanging (using light weights!) The act of walking will cause movement and some slight jarring which will put extra stress on the penis.

Follow this mans good advice, he's given you a model for how proper, effective but safety-conscious hanging should be done, down to the last detail.

http://i295.photobucket.com/albums/m...ngerlayout.jpg
http://i295.photobucket.com/albums/m...edwweights.jpg

Here is a setup that I personally made myself and have provided to a lot of people, who've had a great deal of success with it and costed them little $$$ Ive used the device myself for years and found this industrial strength approach never failed. It could handle more weight then you'd ever need and is very sturdy, mostly consisting of steel and hardened plastic that would be flexible enough where you'd need it to be.

First I apply the yellow wrap tightly to my FLACCID penis, which gives a good traction base. Then the cotton wrap over top, bound with a pair of rubber bands. The penis is then inserted into the shield with the head of the penis facing the pointed end of the shield, dorsal side laying atop the concave end of the shield. The penis is then bound in with a solid velcro strap fastener, made comfortable by the rubber - cotton - rubber layering applied first. Do a tug test to insured it is secured properly and comfortable. once mastered, I could pull with all my strength and the device would be comfortable. The weight is attached to a thick steel stain with a rope tie mounted on the end as a stopper. The other end of the chain is then secured to the small chain mounted to to the shield, via S-Hook.

It really is a very effective and industrial strength design of my own that has made many people content. Just putting it out there for all who are curious and for the hardcores who can't get enough :P

[millia Senior Member;PEGym Editor Find all posts View Profile Close millia]

What is exhibit A, sir?

[Dustpan Senior Member Find all posts View Profile Close Dustpan]

Millia,

How are you doing with the hanger?

[Waylander Retired ModeratorPEGym EditorPEGym Hero Find all posts View Profile Close Waylander]

Thanks sizedoctor! That looks fairly simple to make. Exhibit A, looks like a pvc pipe, split in half, and shaped to fit under the penis?
(Good pics) I'm curious about how you use some of the other items though. Are the rubber bands and velcro ties for holding the wrap?

[millia Senior Member;PEGym Editor Find all posts View Profile Close millia]

I wish I was doing great Dustpan, but alas I have broken 3 bones in my foot the night I intended to try out your hanger, so no hanging for me for the next 6-8 weeks.

[Waylander Retired ModeratorPEGym EditorPEGym Hero Find all posts View Profile Close Waylander]

I wish I was doing great Dustpan, but alas I have broken 3 bones in my foot the night I intended to try out your hanger, so no hanging for me for the next 6-8 weeks.

Your supposed to wear steel toe boots when you heavy hang!! LOL, just kidding . Sorry to her about your foot millia. Injuries always suck.

[millia Senior Member;PEGym Editor Find all posts View Profile Close millia]

Haaaa haaa haaa haaa. It's all good just a new experience to learn from.
Plus its getting my forearms RIPPED. As well as my arms. I love it so far. Hopefully my left leg is going to be decently sized as well from all the weight it has to handle.