Quick Extender Pro Optimization and FAQ

[Cherryguy Junior Member Find all posts View Profile Close Cherryguy]

Hello, quick question, is the base ring(part L) supposed to be in a fixed non moving position? Mines swivels up and down and when I try to strap in and compress the springs, if I press to hard it can cause the base ring to swivel in and up or down direction, which makes it more difficult to strap in. Also I have not added any extension rods as of yet as I am still trying to get used to wearing this device, but I notice that If I use my fingers and move the silver rods left or right that they seem loose, is this normal, or are the rods supposed to not be slack? Also what are those two things located on each rod right at the bottom of the base ring? Do those things serve a purpose? Thank you for any help and sorry for all the questions.

[lmspey Member Find all posts View Profile Close lmspey]

Disregard the lines, strap in and you will know how much stretching is right. Takes time to get the right amount of rods to start, but the video is pretty good as a starting point. I unscrew the base rod from the blue mount as the days go by, once its about to fully unscrew, I add a rod. This can take weeks.
Loose equals normal, just make sure the extension rods are nice and tight. It's meant to flex so when you move around with it under your shorts, etc, it to can move and not bind.

[Geortik Junior Member Find all posts View Profile Close Geortik]

Do you compress the springs when you put the device on? The springs should be all the way pressed in with the burrito inserted and noosed down before you release the tension. If you have worn the device for that many hours and that much time and not added several rods, you are doing something wrong.

What do you.mean by springs should be all the way pressed in with the burrito inserted and noosed down before you release the tension? I was just put my glans through the straps and then closed them and of course i add rods when i have to ? Did i do something wrong?

[Ultimate Burrito Moderator Member of the Month Oct 2017PEGym Hero Find all posts View Profile Close Ultimate Burrito]

What do you.mean by springs should be all the way pressed in with the burrito inserted and noosed down before you release the tension? I was just put my glans through the straps and then closed them and of course i add rods when i have to ? Did i do something wrong?

If you are new to using the extender and following the program they outlined then you should be fine. As you get into more advanced phases of using the device you'll need to compress the extender to put it on and once it is secured to the burrito and let go of the device the springs will decompress adding additional tension while wearing.

[Cherryguy Junior Member Find all posts View Profile Close Cherryguy]

Hello I have two questions. I notice that the head of my penis goes cold and my penis goes numb after stretching for about 1 and half to 2 hours. I never stretch for more than 2 hours. I understand this is because bloodflow is being restricted. Still I am concerned and freaked out about it. Is this normal? Do I have anything to worry about regarding this, or things I can do to minimize it?

Also is there a best schedule for effectiveness. Currently I am extending Mon-Fri, with the weekends off. Or is it better to extend for like 3 days, take a day off, extend for 3 days, take a day off. Is there an optimal routine for effectiveness and recovery? Thank you for your time and any help.

[Cunny Linguist Senior Member Member of the Month May 2021 Find all posts View Profile Close Cunny Linguist]

Extending for 5 days and then taking 2 days off is fine. That's pretty much the routine that I follow. I personally don't extend more than 90 minutes at a time and it's probably not a good idea to extend longer than that.

[mikiflex Junior Member Find all posts View Profile Close mikiflex]

Can someone please recommend me a way to buy Quick Extender Pro within the EU? I don't want to order it from USA and go through filling out customs papers. I am looking for reseller information or alternative product recommendation or someone willing to be an intermediary. Thanks.

(I know, 11 years, don't be like me)

[alltemmeee Junior Member Find all posts View Profile Close alltemmeee]

I have been using it for the better part of seven months and have measured about an inch gained. The springs in it are pointless. I compress it as much as possible to get it fitted, then I unscrew the adjusting screws out as far as they will go. The poor design of the base makes it painful to wear, but by forcing it to stretch things out, it does seem to work.

[Cunny Linguist Senior Member Member of the Month May 2021 Find all posts View Profile Close Cunny Linguist]

I have been using it for the better part of seven months and have measured about an inch gained. The springs in it are pointless. I compress it as much as possible to get it fitted, then I unscrew the adjusting screws out as far as they will go. The poor design of the base makes it painful to wear, but by forcing it to stretch things out, it does seem to work.

The springs are basically meant to act as a 'shock absorber' to help reduce the risk of injury if you were to move in a way that might put a significant strain on your penis. I personally have not found the base to be painful. I recommend using baby powder on your penis and scrotum before you use the QEP. This helps to keep the skin dry and prevents the skin from 'sticking' to the base.

[Mrbahama Junior Member Find all posts View Profile Close Mrbahama]

I am on day seven of the initiation phase so far so good. I have followed the directions but I’m still not certain what the turning knobs on the rods near the base are for. When and why would you use them? Also due to my career I wear this device at work and would like to hear from others who may have advice or tips about wearing it discreetly. Thanks

[DeepDawg Junior Member Find all posts View Profile Close DeepDawg]

Hello all,

(This is a repost from a post a just made in another forum, I figured I would add it here since you all have experience with device, and help is greatly appreciated)

So I started my PE Journey a little over a month ago by using the Quicker Extender Pro penis extender. My main focus is straightening out my curve.

Here is my exact log of how my training has been going:

QEP


Total Hours: 123


Initial device size: 4.6”



Week of Dec. 27 (Week 1)

Monday: 3

Tuesday: 3

Wednesday: 3

Weekly hours: 9




Week of Jan. 3 (Week 2)

Monday: 3

Tuesday: 3

Added a small extension (0.2”)

New device size: 4.8”

Thursday: 6

Friday: 6

Weekly hours: 18




Week of Jan. 10 (Week 3)

Monday: 6

Tuesday: 4

Wednesday: 2

Thursday: 5

Saturday: 6

Added a small extension (0.2”)

New device size: 5.0”


Weekly hours: 23




Week of Jan. 17 (Week 4)

Monday: 6

Tuesday: 8

Wednesday: 8

Friday: 8

Saturday: 5

Added a small extension (0.2”)

New device size: 5.2”

Weekly hours: 35




Week of Jan. 24 (Week 5)

Tuesday: 6

Wednesday: 5

Thursday: 6

Saturday: 8

Sunday: 5

Weekly hours: 30




Week of Jan. 31 (Week 6)

Tuesday: 7

Wednesday: 1


I've been following the guide that the manufacturer provides. After 3 weeks I was feeling great and my EQ was amazing. But now in the beginning of week 6 my EQ has seemed to go down quite a bit and I'm very upset about it, my piece almost feels a little smaller. Should I stop? I was following a 5 days a week regiment, thinking that 2 rest days a week was enough but maybe it's not. I also read on here that maybe it is due to the fact that I'm using a noose style extender. If this product is one step forward and 2 steps backward, can anyone recommend a different device, or effective way to straighten out by penis by lengthening the shorter side. I'm very conflicted about this. I've also been seeing a new girl and the bedroom time is quickly approaching, I want to make sure I'm ten hut when that time comes, should I take an indefinite break from using this device?

Any help or advice is greatly appreciated,
Thanks!